Главная » Интернет-магазин » Стартовые наборы |
Joyetech eGrip OLED 30W VT Kit 1500mAh
|
Joyetech eGrip OLED 30W VT Kit 1500mAh
30W Joyetech eGrip OLED VT MOD, applies with the Variable Temperature Control system, supporting VT-Ti (Titanium)/ VT-Ni (Nickel-200)/ VW mode with an OLED screen. It also boasts a 360-degree regulation ring to adjust output wattage or temperature. The compact size with multiple colors catering to your preference makes it always comfortable to hold.
Indications:
1.Screen: The OLED screen presents watts, ohms, temperature, battery life and timing while vaping.
2.No Atomizer Alert: When the coil is not installed properly, the screen will appear “No Atomizer”.
3.New Coil Alarm: When installing a new coil whose resistance is larger than the previous one to some degree, resetting the “basic resistance” (resistance at room temperature) shall be required.
After fitting a new coil, press the fire button while the atomizer base is removed to initiate a reset. After you reinstall the atomizer base with a new head, the screen will appear “new coil up, same down”. Rotate the regulation ring clockwise to confirm that a new coil has been fitted.
Should you see this message for any other reason, especially when reinstalling the same coil that is still warm after use. If so, rotate the regulation ring counterclockwise so that the ‘basic resistance” won’t be reset.
4.Device Too Hot Alert: When the device’s inner temperature passes over 70℃, the output will shut off automatically and the screen will appear “Device Too Hot” for 5 seconds. After then, it switches back to normal.
5.Temperature Protection: Under VT mode, if the coil’s actual temperature reaches to the set temperature, the device will show “Temp Protection”.
6.Over 10s Protection: If you keep pressing the fire button for more than 10 seconds, the screen will appear “Over 10S”.
7.Atomizer Short-circuit Protection: When atomizer short-circuit occurs, the screen will appear “Atomizer Short”.
8.Atomizer Low Alert: When the atomizer resistance is lower than 0.4ohm under VW mode or lower than 0.2ohm under VT mode, “Atomizer Low” will appear on the screen.
9.Low-voltage Protection: When the battery voltage is lower than 3.3V, the screen will appear “Battery Low” and “Lock”. Thus the battery is locked. Recharging to unlock the battery.
Note:
1.Under VT mode, please install the temperature control coils at room temperature ;
2.Only use temperature control coils under VT mode. Damages will be caused when temperature control coils are accidentally used under VW mode.
3.VT mode only supports a maximum of 1.0ohm. It will automatically switch to VW mode when the coil is larger than 1.0ohm or using a normal coil under VT mode.
Характеристики:
Size: 46.4mm*20.4mm*99.5mm (including mouthpiece)
Battery Capacity: 1500mAh
Output Mode: VT-Ni/VT-Ti/VW Mode
E-juice Capacity: 3.6ml
Resistance Range:
0.2-1.0ohm for VT mode
0.4-3.5ohm for VW mode
Комплектация:
1 x eGrip Mouthpiece
1 x eGrip VT body
1 x eGo ONE CL head 1.0ohm
1 × eGrip VT Vent Pipe
1 x eGrip CL base
1 x eGo ONE CL-Ni head 0.2ohm
1 x eGo ONE CL-Ti head 0.4ohm
1 x 1A Wall Adaptor
1 x USB Cable
1 x Manual & Warranty Card
У нас вы можете купить Joyetech eGrip OLED 30W VT Kit 1500mAh по самой низкой цене среди магазинов в Украине.
30W Joyetech eGrip OLED VT MOD, applies with the Variable Temperature Control system, supporting VT-Ti (Titanium)/ VT-Ni (Nickel-200)/ VW mode with an OLED screen. It also boasts a 360-degree regulation ring to adjust output wattage or temperature. The compact size with multiple colors catering to your preference makes it always comfortable to hold.
Indications:
1.Screen: The OLED screen presents watts, ohms, temperature, battery life and timing while vaping.
2.No Atomizer Alert: When the coil is not installed properly, the screen will appear “No Atomizer”.
3.New Coil Alarm: When installing a new coil whose resistance is larger than the previous one to some degree, resetting the “basic resistance” (resistance at room temperature) shall be required.
After fitting a new coil, press the fire button while the atomizer base is removed to initiate a reset. After you reinstall the atomizer base with a new head, the screen will appear “new coil up, same down”. Rotate the regulation ring clockwise to confirm that a new coil has been fitted.
Should you see this message for any other reason, especially when reinstalling the same coil that is still warm after use. If so, rotate the regulation ring counterclockwise so that the ‘basic resistance” won’t be reset.
4.Device Too Hot Alert: When the device’s inner temperature passes over 70℃, the output will shut off automatically and the screen will appear “Device Too Hot” for 5 seconds. After then, it switches back to normal.
5.Temperature Protection: Under VT mode, if the coil’s actual temperature reaches to the set temperature, the device will show “Temp Protection”.
6.Over 10s Protection: If you keep pressing the fire button for more than 10 seconds, the screen will appear “Over 10S”.
7.Atomizer Short-circuit Protection: When atomizer short-circuit occurs, the screen will appear “Atomizer Short”.
8.Atomizer Low Alert: When the atomizer resistance is lower than 0.4ohm under VW mode or lower than 0.2ohm under VT mode, “Atomizer Low” will appear on the screen.
9.Low-voltage Protection: When the battery voltage is lower than 3.3V, the screen will appear “Battery Low” and “Lock”. Thus the battery is locked. Recharging to unlock the battery.
Note:
1.Under VT mode, please install the temperature control coils at room temperature ;
2.Only use temperature control coils under VT mode. Damages will be caused when temperature control coils are accidentally used under VW mode.
3.VT mode only supports a maximum of 1.0ohm. It will automatically switch to VW mode when the coil is larger than 1.0ohm or using a normal coil under VT mode.
Характеристики:
Size: 46.4mm*20.4mm*99.5mm (including mouthpiece)
Battery Capacity: 1500mAh
Output Mode: VT-Ni/VT-Ti/VW Mode
E-juice Capacity: 3.6ml
Resistance Range:
0.2-1.0ohm for VT mode
0.4-3.5ohm for VW mode
Комплектация:
1 x eGrip Mouthpiece
1 x eGrip VT body
1 x eGo ONE CL head 1.0ohm
1 × eGrip VT Vent Pipe
1 x eGrip CL base
1 x eGo ONE CL-Ni head 0.2ohm
1 x eGo ONE CL-Ti head 0.4ohm
1 x 1A Wall Adaptor
1 x USB Cable
1 x Manual & Warranty Card
У нас вы можете купить Joyetech eGrip OLED 30W VT Kit 1500mAh по самой низкой цене среди магазинов в Украине.
Теги: